X-Fab shows how to use Tanner EDA with for AMS design

June 29, 2021 // By Peter Clarke
X-Fab shows how to use Tanner EDA with for AMS design
European specialty foundry X-Fab Silicon Foundries SE has released a reference design kit for Siemens' Tanner range of analog and mixed-signal EDA software.

It is now possible to set up the physical design kit for X-Fab's XH018 180nm modular mixed-signal high-voltage CMOS process on Siemens' Tanner AMS tools. The reference design kit provides support for tool set-up, design and simulation flow, as well as demonstrating how designers can use X-Fab PDKs to perform physical verification tasks.

"Reference design kits have proved themselves to be pivotal in demonstrating the design flows that can be achieved using X-Fab process design kits and IPs. By adding a kit that is dedicated to Siemens’ Tanner AMS design tools to our overall offering, we are able to address the needs of an even greater customer base," said Lars Bergmann, director of design support at X-Fab, in a statement.

Tanner custom IC design tools from Siemens feature schematic and layout editors and can be integrated with circuit simulators and platforms for design rule checking, parasitic extraction and physical verification

Related links and articles:

www.xfab.com

News articles:

Siemens takes over UK chip-level analytics expert UltraSoc

Synopsys buys Moortec to take on Mentor

China applies pressure to close foundry acquisition deal


Vous êtes certain ?

Si vous désactivez les cookies, vous ne pouvez plus naviguer sur le site.

Vous allez être rediriger vers Google.